Hello,
My FIOS install started off with the ONT bridging WAN to MoCA/Coax, but I called an had tech support change the ONT to bridge WAN to Ethernet (so I could use my old router with VPN as a primary, and didn't use the ActionTec at all).
Since then, I removed the old router and configured the ActionTec as primary (using only Ethernet and leaving the ActionTec's Coax disconnected), and everything has been working fine. Now, however, I have some MoCA enabled devices, and wanted the ActionTec to bridge the MoCA LAN to the Eth LAN and to the WAN.
When I connected the Coax to the ActionTec, it appeared that it favored that connection, dropped it's Etherner WAN lease, and attempted to connect to the WAN over MoCA. I judged by my lack of Internet connectivity that it wasn't able to do so (and the ActionTec httpd main page connection status indicated as much), and that my ONT needs to be reconfigured to bridge WAN to MoCA/Coax.
If tech support can make this change, I would appreciate it (and if this isn't the correct forum in which to post such requests, a pointer to the correct spot would also be appreciated), Thanks
The name on my account is
Ed Morris